Payment & Shipping Terms:
|Rated Pipe Size:||114 × 12mm||Swaging Condition:||Hot Swaging & Cold Swaging|
|Rated Press Force:||250ton||Weight:||About 11ton|
|Voltage:||380V Or As Required||Frequency:||50HZ Or As Required|
Tube Swaging Pointing Machine,
Tube Swaging Crimping Machine,
hydraulic heading machine
Hydraulic Tube Swaging And Crimping Machine For 114mm Cold Drawn Carbon Aluminum Steel
I. Why one end of cold drawn pipes and bars are needed to be crimped before drawing?
Before cold drawing, one end of raw pipes and bars should pass through the die and clamped by jaw, then under pulling force of cold drawing machine, the rest of the material pass through the die and get required size. So the raw material need to be crimped and swaged at first on the crimping machine. Hydraulic swaging and crimping machine is one of the machine to point head.
To swaging large pipe head, the pointed end of raw material should be heated and then put it into the swaging machine. The swaging machine is often used at the end of hot rolling line, the hot pierced hollow tube with waste heat enter the swaging machine and make the pointing work more easily.
II. Main parameter of hydraulic swaging and pointing machine
|1||Rated press force||ton||250|
|7||Rated capacity||mm||Φ114×12 (heated)|
|8||Overall size||Main machine||2800×1150×2350|
III. Main components of hydraulic pointing machine
IV. Photos of Hydraulic crimping machine
Contact Person: Joanna