Payment & Shipping Terms:
|Drawing Speed:||0||Drive Type:||0|
|Drawing Material:||Welded Tubes||Condition:||Brand New|
LW5 tube drawing machine,
welded tube cold drawing machine,
LW5 Cold Drawing Machine
LW5 Cold Drawing Machine For 6 ~ 20mm Welded Steel Tubes With Thin Wall Thickness
Cold drawing machines with advantages of simple structure, easy operation and low fault rate, are often used to improve the quality of welded tubes. LW5 single chain cold drawbench is designed to draw welded steel tubes from 6mm to 20mm. And the wall thickness of tubes are less than 3mm. The effective drawing length is designed in according to customer's requirement.
II. Main Parameter of LW5 (5ton) Cold Drawing Bench
|1||Max. drawing force (ton)||5|
|2||Max. drawing length (m)||9 (or as request)|
|3||Rated drawing speed (m/min.)||20 (fixed speed or adjustable speed)|
|4||Drawing range (mm)||6 ~ 20|
|5||Drawing material||welded carbon steel tubes|
|6||Main motor type||Y180L-4-18.5|
|8||Main drive chain||t=78.18|
|9||Mandrel device||Optional part|
Note: the mandrel device is used to reduce the wall thickness of cold drawn tubes at the time of drawing, it is an optional part, If the drawing machine is only used to reduce the outer diameter, the mandrel device is useless.
III. Preparation before cold drawing
1. If the raw material with high strength, it should be annealed;
2. Before cold drawing, one end of the raw material should be pointed to made it pass through the cold drawing die smoothly.
IV. Photos of cold drawing machine with dies
Contact Person: Joanna