Payment & Shipping Terms:
|Name:||Elevator Guide Rail Pointing Machine||Roller Material:||1|
|Qty. Of Rollers:||1||Motor:||37kw|
|Pointed Length:||1||Voltage:||380V Or As Required|
|Frequency:||50HZ Or As Required||Condition:||Brand New|
Elevator Guide Rail Pointing Machine,
T50 T70 Pointing Machine,
Cold Drawn Pointing Machine
Metal Pointing Rolling Machine For Elevator Guide Rail T50 T70A
Pointing machine is used to make head of raw material before cold drawing. One end of raw material is pointed smaller than drawing die with enough length, which can be bit firmly by jaw of cold drawing machine.
Pointing machine rollers for elevator guide rail are special designed in according to the size of the rails. There are two rollers on the machine and driven by motor, the rollers are made from 9Cr2Mo, and the surface of rollers are heat treated with high hardness.
Before pointing, the raw material should be heated to a certain temperature to ensure it is easy deforming. After pointing, the guide rail can be drawn on the cold drawing machine.
II. Main parameter
||For elevator guide rail T45, T50, T70|
||Include in electric control cabinet, without wire and wire tube used at site.|
IV. Structure and work principle
The machine is made of machine frame, motor drive system, main gear reducer, roller assembly etc.
Starts the motor and drives main gear reducer, the outputted power from gear reducer is transferred to up and lower roller and made them antiport at the same speed via couplings and gears. When the end of the material touched with working groove, it was rolled and smaller than original. Select the corresponding roller groove, repeat the above working process, and pay attention to adjust the gap between the upper and lower rollers, so that the material end can be rolled into the required size, shape and length.
V. General drawing of pointing machine
Contact Person: Joanna